Skip to content

Air Duct Sealing in Austin, TX

We seal leaking air ducts, loose boots, and damaged duct connections.

A technician kneeling on a flat commercial roof with a tablet in his hands, beside a rooftop unit with its wiring panel open

Older Austin homes with attic ductwork and aging flex-duct collars are where we most often find air leaks. Houses in Austin, Rollingwood, West Lake Hills, and Lost Creek can have long runs above the ceiling, where heat, movement, and worn tape loosen a duct connection at the plenum, branch line, or register boot.

Leaks around a supply duct can send cooled air into an attic instead of the bedroom, hallway, or living room below. Return-side gaps can also draw attic dust and unconditioned air toward the air handler, leaving some vents weak even when the system is running.

Duct sealing should not be put off when a joint has separated, insulation is wet, or a room has stopped receiving normal airflow. A gap in a duct run keeps wasting conditioned air and can allow a loose section to pull farther away from its collar.

Hot rooms and whistling vents

A hot upstairs room, a weak ceiling vent, a whistling sound behind a grille, or air blowing into the attic are all reasons to check the ductwork. Customers also call when one room stays warmer than the thermostat setting, a register barely moves air, or dust appears around a vent cover after the system starts.

A whistle can come from a loose boot, while a weak vent may come from a crushed flex duct, a disconnected branch run, or a leak at the supply plenum. Those faults can feel similar from the room below, but the repair materials and labor depend on the exact section of duct that is damaged.

Duct leakage inspection

Our inspection follows the duct path from the air handler to the supply registers and return grilles. We check the plenum, collars, metal joints, flex-duct liners, insulation jacket, mastic, tape, and register boots, then look for separated connections, kinks, tears, and visible air movement.

A straightforward duct check can take around 30 to 60 minutes, with more time needed when runs are behind drywall or deep in an attic. We can usually seal accessible joints with mastic or approved tape during the visit; a damaged run that needs replacement, a buried boot, or access work may need to be scheduled separately.

Attic access and damaged duct runs

Price changes most with attic access, the location of the leak, and the condition of the duct run. An exposed collar near the air handler is different from a split flex duct behind insulation, above a vaulted ceiling, or at a register boot reached through a tight crawlspace.

Material also affects the scope when the inner liner, outer insulation jacket, or metal plenum has deteriorated rather than simply come loose. A run that can be resealed uses different work than one needing a new section, and an alteration that requires inspection or sign-off adds steps before the ductwork is closed.

Air handler model plate and attic access

Have the air handler model number and the room with the weak vent ready when you call. The model plate is commonly on the cabinet near the air handler, and the room location helps us trace the correct supply branch instead of checking every register.

Tell us whether the system is running, whether air is coming from the vent, and whether the attic hatch, garage platform, or closet provides access to the ductwork. Let us know if you can see a loose duct, torn insulation, or a disconnected collar. Call Air Conditioning Services Austin at (737) 300-9206 before a loose duct continues sending cooled air into the attic instead of the room.

Next: get in touch, or back to the home page.